Table of Contents
Advertisement
SETUP PROCEDURE
■ Installation of the Setup
Software and Setup Procedure
You will connect the iris reader and setup PC with the setup
cable supplied to the administration software, and carry out
the setup using the setup software installed from the CD-
ROM into the setup PC.
● Platform
To install the setup software, the PC should meet the follow-
ing requirements.
IBM PC or 100 % compatible / Pentium
/ 128 MB RAM / 2 MB hard drive space
In addition, the setup PC must be equipped with a CD-
ROM drive and a D-sub 9 pin serial port.
• Operating system requirement
®
Microsoft
Windows
®
or Microsoft
Windows
• Video display setting requirement
800 x 600 resolution
● Installation/Uninstallation
• Installation
Insert the supplied CD-ROM into the CD-ROM drive on the
setup PC. Double-click "Setup.exe" in the "Initial-ET330"
folder. Then, follow the directions given and respond to the
dialog boxes.
You will be asked to enter the product key during the instal-
lation. The product key is written on the CD-ROM case. The
product key is common between the administration soft-
ware and the setup software.
• Uninstallation
When the setup software becomes unnecessary, open
"Add/Remove Programs" in "Control Panel" and select "BM-
ET330 setup software". The setup software will be unin-
stalled from the setup PC.
12
®
300 MHz or higher
®
2000 Professional Service Pack 4
®
XP Professional Service Pack 2
● Initial Setup Procedure
Installation and connections are completed.
Note: The power should be turned off.
1
The front cover is detached from the iris reader.
Setup switches are configured.
2
Switch 1 is set to OFF. (The "setup" mode is
activated.)
Switch 3 is set to ON. (The "tamper detection" mode is
canceled.)
The iris reader and setup PC are connected with the
3
exclusive setup cable supplied with the administration
software.
The power is supplied to the unit.
4
The setup software is booted and the setup of iris
5
reader is carried out.
The power supply to the iris reader is shut down. Then, the
6
setup cable is removed from the iris reader and setup PC.
Setup switches are configured.
7
Switch 1 is set to ON. (The "normal operation" mode is
activated.)
Switch 3 is set to OFF. (The "tamper detection" mode
is activated.)
8
The front cover is attached to the iris reader.
Advertisement
Table of Contents
