Ft128 Display Cp Indicators; Table 5 Led Indicators On Control Panel (Cp) - Panasonic Firetracker FT128 Operation Manual

3.4.1.2

FT128 Display CP Indicators

Table 5 LED indicators on Control Panel (CP)

NO.
Indicator
L7 General fault
L8 Disablements
L9 Test mode
L10 Door open
Fault TX
L11
activated
L12 Service
Fault /
Disablements
L13
Alarm devices
L14 System fault
Fault /
Disablements
L15
Fire Brigade
TX
Fire Brigade
L16
TX delay
12
This is also valid when FT128 has no "contact" with a unit with such an output, e.g. 4477, 3379, 3364, etc.
13
The LED is turned on during restart and stays on for restart code other than 00, 03 or 25 until the fault is acknowledged.
14
This is also valid when EBL128 has no "contact" with a unit with such an output, e.g. an I/O unit 3361, etc.
15
The Alert Annunciation function is described in the FT128 Technical / Programming Manual, chapter "Alert annunciation". The
LED "L16" will be "on" if the AA function is enabled for at least one alarm point / zone. Normally, only one time channel used
for this function but two or more channels can be used. The AA function can, as an alternative, be continuously "on".
LED Colour
Yellow
Yellow
Yellow
Yellow
Yellow
Yellow
Yellow
Yellow
Yellow
Yellow
Indicating
Fault(s), i.e. not acknowledged fault(s) and/or
acknowledged but not corrected fault(s).
Something is disabled / disconnected via a menu,
via a disable switch or via a button in the zone
control module if fitted.
One or more zones are in "test mode" (see menu
H7).
A door is open in FT128 control panel.
One or more non-acknowledged faults:
•
Output for fault TX (routing equipment) is
activated.
•
Test of routing equipment in progress (see
menu H1).
•
Sensitive fault detection mode is on. See
menu Sensitive Fault Detection Mode
(H5/A2).
One or more sensors have reached the service
level. See menu H4/U4.
Steady light: output(s) type "Alarm device" is / are
disabled.
Flashing light: output(s) type "Alarm device" have
generated fault(s) 12 .
FT128 is not running due to S/W, CPU or memory
fault) 13 .
Steady light: Output(s) for "Routing equipment"
disabled via menu H2 / B5 or via open door.
Flashing light: Routing equipment power supply
output or supervised outputs type "Routing
equipment" have generated fault(s)
The Alert Annunciation function is enabled, i.e. the
time channel controlling this function is "on".
18
Operation Manual
FT128 Rev 2.4
14
.
15