Table of Contents
Advertisement
5
New 19" Rack Cabinet & New Loop Modules
5.1
Cabinet Overview
The design of the new Brooks 19" rackmount FT128 cabinet is in accordance with the
industry standard for 19" rackmount equipment. The 19" rackmount enclosures are
available in the following cabinet size:
•
Large enclosure 1078mm High x 600mm wide x 250mm Deep.
•
Small enclosure 678mm High x 600mm wide x 250mm Deep Figure 11 below .
•
Battery enclosure 290mm High x 600mm Wide x 250 mm Deep.
Any combination of the three sizes can be manufactured. The battery enclosure is normally
fitted below either of the large or small enclosure to allow for larger batteries should the
need arises. When the battery enclosure is to be used with the large enclosure, the whole
cabinet should be mounted on a plinth on the floor such that the LCD display would be at
the eye level.
The addressable FT128 19" rack panels are fully customisable to site requirements and its
racks are modularised in design.
A possible layout for FT128 Mounted in small 19" Rack Cabinet is shown in Figure 11
below.
5.2
Enclosure Components
Each small or large cabinet can be fitted with standard and optional face plates, equipment
plates, ancillary racks, etc. The available plates as follows:
•
FT128 6U face plate with OWS display module (CB678)
•
FT1020G3 or FT128 equipment Plate for small 19 Inch Rack (CB677)
•
Standard Ancillary 3U Rack for mounting display modules (CB681)
•
Standard 3U Blank Rack to fill up the unused racks (CB683)
•
10HP Blank Cover (CB684)
Figure 11 FT128 Mounted in Small 19" Rack Enclosure
28
Operation Manual
FT128 Rev 2.4
Advertisement
Table of Contents
