Table of Contents
Advertisement
23.7
Version and Alarm Counter (H4/U7)
This menu can be used to show the following information:
Version: FT128 software / firmware version downloaded to the main board 4556.
Alarm counter: The alarm counter is increased with "1" every time the FDCIE. enters the
real "fire alarm condition" (Fire alarm indication in the display, LEDs "Fire" lit and the FDCIE
buzzer sounding), i.e. not for zones in test mode. It starts on 000 and goes to 999. It can
be reset to 000 via EBLWin (Control unit menu "Reset alarm counter..."). It is stored in an
EEPROM, i.e. the value will be retained also after the FDCIE. has been de-energized.
Action
Text in display
"Access"
Scroll to menu H4.
Present system status
Disablement
"A"
Version and alarm counter
Scroll to menu U7.
"A"
Version: X.X.X
Alarm counter: YYY
Version and alarm counter
"Return"
Present system status
"Return"
ACCEPT? H4
ACCEPT? U1
ACCEPT? U7
ACCEPT? U7
ACCEPT? H4
108
Operation Manual
FT128 Rev 2.4
Comments
Log on to FT128 as shown
in page 35.
Press "A" to accept.
Press "Return" to menu
U7.
Scroll or press "Return" to
menu H4.
Scroll or press "Return"
Advertisement
Table of Contents
