Rigol DS6000 Series User Manual page 173

6 To Make Measurements
with the transient moving of the waveform). Thus, the X value might
change even though you do not adjust the cursor.
When AXIS is set to "Y",
Adjust cursor A: press CursorA and use

position of cursor A. During the adjustment, the measurement result will
change accordingly. The adjustable range is limited within the screen.
Adjust cursor B: press CursorB and use

position of cursor B. During the adjustment, the measurement result will
change accordingly. The adjustable range is limited within the screen.
Adjust cursor A and B at the same time: press CursorAB and use

adjust the horizontal positions of cursor A and B at the same time. During
the adjustment, the measurement results will change accordingly. The
adjustable range is limited within the screen.
Note: The cursor will track the marked point (namely jumps up and down with
the transient moving of the waveform). Thus, the Y value might change even
though you do not adjust the cursor.
4. Select Track Type
Press Type to select "Oldest" or "Latest" to be the track type of X cursor.
Note: The Type softkey is only available when AXIS is set to "X".
Oldest: When you adjust the vertical position of Y cursor, if the waveforms

of corresponding measurement channels have formed multiple crossing
points along the cursor, then the X cursor will be automatically positioned
from the crossing point at the most left side of the screen.
Latest: When you adjust the vertical position of Y cursor, if the waveforms

of corresponding measurement channels have formed multiple crossing
points along the cursor, then the X cursor will be automatically positioned
from the crossing point at the most right side of the screen.
5. Measurement Example (When AXIS is set to "Y")
Use cursor A and B to measure the waveforms in CH1 and CH2 respectively. You
would discover that the cursors would track the marked points when the
waveforms are expanded or compressed horizontally.
DS6000 User's Guide
to adjust the horizontal
to adjust the horizontal
RIGOL
to
6-37