Remote Control Via Gpib - Rigol DS6000 Series User Manual

RIGOL

Remote Control via GPIB

1. Connect the device
Use the USB to GPIB interface converter to extend a GPIB interface for the
oscilloscope. Then connect the oscilloscope to your PC using a GPIB cable.
2. Install the driver of GPIB card
Install the driver of the GPIB card which has been connected to the PC correctly.
3. Set the GPIB address
Set the GPIB address of the oscilloscope according to the description in "To Set
the GPIB Address".
4. Search device resource
Start up Ultra Sigma and click
figure below. Click
the instrument resource currently connected to the PC through the GPIB
interface. The name of the device resource found will be displayed on the right
side of the panel. Click
remove the unwanted resource, click the resource name to select it and then
click
If resource cannot be found automatically:
Select the GPIB card address of the PC from the dropdown box of "GPIB::"

and select the GPIB address set in the oscilloscope from the dropdown box
of "::INSTR".
Click

14-8
and the software will automatically search for
.
to check whether the GPIB communication works
to open the panel as shown in the
to add the resource. Note that if you want to
14 Remote Control
DS6000 User's Guide