Rigol DS6000 Series User Manual page 146

RIGOL
Press MATH  Operate to select "Logic":
Press Formula to select the desired operation formula and the default is AND.

Press Source A and Source B to select the desired channels. The channels

available are CH1, CH2, CH3 and CH4.
Press Invert to turn the invert display of the operation results on or off.

VERTICAL

POSITION and HORIZONTAL
display of the operation results.
Press Threshold A and use

operation.
Press Threshold B and use

operation.
Press Label to turn on the label modifying interface. You can refer to the

introduction in "Channel Label" to set the label of the math operation
waveform. Note: The new label can include uppercase English letters (A to Z),
lowercase English letters (a to z), numbers (0 to 9), underlines and spaces and
the length cannot exceed 4 characters.
6-10
POSITION, VERTICAL
to set the threshold of source A in logic
to set the threshold of source B in logic
SCALE, HORIZONTAL
SCALE can also be used to adjust the
6 To Make Measurements
DS6000 User's Guide