Rigol DS6000 Series User Manual page 116

RIGOL
−
UpLevel
=
SlewRate
TimeSettin
The adjustment mode of the trigger level is different when different vertical window
is selected:
: only adjust the upper limit of the trigger level. During the adjustment,

the "UP Level" and the "Slew Rate" change accordingly but the "Low Level"
remains unchanged.
: only adjust the lower limit of the trigger level. During the adjustment, the

"Low Level" and the "Slew Rate" change accordingly but the "UP Level" remains
unchanged.
: adjust the upper and lower limits of the trigger level at the same time.

During the adjustment, the "UP Level" and the "Low Level" change accordingly
but the "Slew Rate" remains unchanged.
Note: If you select "Slope" under the Type menu, you can press down Trigger
LEVEL continuously to switch over the options under the Vertical menu.
Trigger Mode:
Press Sweep to select the Trigger Mode (page 5-3) under this trigger type as auto,
normal or single. The corresponding status light of the current trigger mode turns on.
Trigger Setting:
Press Setting to set the trigger parameters (trigger holdoff) under this trigger type.
5-14
LowLevel
SlewRate
gValue
5 To Trigger the Oscilloscope
−
UpLevel LowLevel
=
TimeUpperL imit
−
UpLevel LowLevel
~
TimeLowerL imit
DS6000 User's Guide