Rigol DS6000 Series User Manual page 113

5 To Trigger the Oscilloscope
Pulse Width Setting:
In this oscilloscope, positive pulse width is defined as the time difference between
the two crossing points of the trigger level and positive pulse; negative pulse width is
defined as the time difference between the two crossing points of the trigger level
and negative pulse, as shown in the figure below.
A
Pulse Width
Pulse Width
A
When the Pulse Condition is set to

Setting and use
to 4 s.
When the Pulse Condition is set to

Lower Limit respectively and use
the upper limit available is from 12 ns to 4 s. The range of the lower limit
available is from 4 ns to 3.99 s. Note: The lower limit of the pulse width must be
lower than the upper limit.
Trigger Mode:
Press Sweep to select the Trigger Mode (page 5-3) under this trigger type as auto,
normal or single. The corresponding status light of the current trigger mode turns on.
Trigger Setting:
Press Setting to set the trigger parameters (trigger holdoff) under this trigger type.
Trigger Level:
Use TRIGGER
description of Trigger Level on page 5-8.
DS6000 User's Guide
B
Positive
Negative
B
to input the desired value. The range available is from 4 ns
LEVEL to modify the level. For details, please refer to the
Trigger Level
Trigger Level
,
or
to input the desired values. The range of
, or
, press Upper Limit and
RIGOL
, press
5-11