Table of Contents
Advertisement
Chapter 7: Configuring the Switch for Stand-alone Operations
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z
awplus(config)#
Warning; This will disable the stacking hardware on member-1.
Are you sure you want to continue? (y/n):
awplus(config)#18:04:12 awplus VCS[2119]: Deactivating
Stacking Ports on stack member 1.
90
4. To move to the Global Configuration mode, type the commands
ENABLE and CONFIGURE TERMINAL.
Figure 39. Moving to the Global Configuration Mode
5. To disable the VCStack feature, type the command NO STACK <id>
ENABLE in the following format:
no stack <id> enable
The id parameter is the ID number of the switch, displayed on the ID
LED. Replace the id parameter with the number on the ID LED. For
example, if the ID number of the switch is 1, the default value, enter
the command as follows:
awplus(config)# no stack 1 enable
6. To disable VCStack on the switch type Y, or type N to cancel the
procedure.
7. Press the Enter key to re-display the Global Configuration mode
prompt.
8. Go to "Saving Your Changes and Rebooting the Switch" on page 91.
Figure 40. Disabling VCStack
Advertisement
Table of Contents
