Connection To The Pu Connector - Mitsubishi Electric FR-E700EX Instruction Manual

2.3.4

Connection to the PU connector

Using the PU connector, you can perform communication operation from the parameter unit (FR-PU07), enclosure surface
operation panel (FR-PA07) or a personal computer etc.
Refer to the figure below to open the PU connector cover.
PU connector
When connecting the parameter unit or enclosure surface operation panel using a connection cable
Use the optional FR-CB2 or connector and cable available on the market.
Insert the cable plugs securely into the PU connector of the drive unit and the connection connector of the FR-PU07 or FR-
PA07 along the guide until the tabs snap into place.
Operation panel FR-PA07
(option)
REMARKS
 Refer to the following when fabricating the cable on hte user side. Keep the total cable length within 20m.
Examples of product available on the market (as of February 2012)
Product
1) 10BASE-T cable
2) RJ-45 connector
To open the cover
Place a flathead screwdriver, etc. in a slot
and push up the cover to open.
Parameter unit connection cable
(FR-CB2 )(option)
Parameter unit FR-PU07
(option)
Type
SGLPEV-T (Cat5e/300m)
24AWG4P
5-554720-3
Control circuit specifications
PU connector
Maker
Mitsubishi Cable Industries, Ltd.
Tyco Electronics Corporation
2
25