Mitsubishi Electric FR-E700EX Instruction Manual page 148

Function assignment of external terminal and control
Setting
Signal
Positive Negative
logic logic
64 164 Y64
68 168 EV
90 190 Y90
91 191 Y91
93 193 Y93
95 195 Y95
96 196 REM
98 198 LF
99 199 ALM

9999

Note that when the speed setting is varied using an analog signal or
ON and OFF depending on that varying speed and the timing of the varying speed due to acceleration/deceleration time setting.
(The output will not alternate ON and OFF when the acceleration/deceleration time setting is "0s".)
REMARKS
 The same function may be set to more than one terminal.
 When the function is executed, the terminal conducts at the setting of any of "0 to 99", and does not conduct at the setting of
any of "100 to 199".
NOTE
 Changing the terminal assignment using Pr.190 to Pr.192 (output terminal function selection) may affect the other
functions. Set parameters after confirming the function of each terminal.
 Do not assign signals which repeat frequent ON/OFF to terminal A, B, C. Otherwise, the life of the relay contact
decreases.
146
Function
During retry Output during retry processing.
The signal is output while the main circuit power
24V external power
supply is off and the 24V power is supplied externally.
supply operation
This signal is available when FR-E7DS is mounted.
Output when any of the control circuit capacitor, main
Life alarm circuit capacitor and inrush current limit circuit or the
cooling fan approaches the end of its service life.
Fault output 3
Output when a fault occurs due to the internal circuit
failure of the drive unit wiring mistake.
(power-off signal)
Average current value and maintenance timer value
Current average value
are output as pulses.
The signal can not be set in Pr.192 A,B,C terminal
monitor signal
function selection.
Output when Pr.503 rises to or above the Pr.504
Maintenance timer signal
setting.
Output to the terminal when a value is set to the
Remote output
parameter.
Output when an alarm (communication error warning)
Alarm output
occurs.
Output when the drive unit's protective function is
Fault output activated to stop the output (at fault occurrence).
The signal output is stopped when the fault is reset.
No function
Operation

of the operation panel, the output of the SU (up to speed) signal may alternate
Refer
Related
to
parameter
page
Pr.65 to Pr.69 164
 
Pr.255 to
245
Pr.259

148
Pr.555 to
249
Pr.557
Pr.503, Pr.504 248
Pr.495, Pr.496 152
Pr.121
204

148
 