Mitsubishi Electric FR-E700EX Instruction Manual page 160

Monitor display and monitor output signal
REMARKS
 By setting "0" in Pr.52, the monitoring of rotation speed (output frequency) to fault display can be selected in sequence by
 When the operation panel is used, the displayed units are Hz and A only and the others are not displayed.
 The monitor set in Pr.52 is displayed in the third monitor position. However, change the output current monitor for the motor load
factor.
Initial Value
 The monitor displayed at power-ON is the first monitor. Display the monitor you want to display on the first monitor and hold
down for 1s. (To return to the rotation speed (output frequency) monitor, hold down
rotation speed (output frequency) monitor.)
Power-on monitor (first monitor)
Rotation speed
(output frequency)
monitor
Example) When Pr.52 is set to "20" (cumulative energization time), the monitor is displayed on the operation panel as described
below.
Power-on monitor (first monitor)
Rotation speed
(output frequency)
monitor
(2) Display set speed (frequency) during
stop (Pr.52)
 When "100" is set in Pr.52, the set speed
(frequency) and
frequency) are displayed during stop and
operation respectively. (LED of Hz flickers
during stop and is lit during operation.)
 The set speed (frequency) displayed indicates the speed (frequency) to be output when the start command is ON. Different from the speed (frequency) setting
displayed when Pr.52 = "5", the value based on maximum/minimum frequency and frequency jump is displayed.
REMARKS
 During an error, the output frequency at error occurrence appears.
 During MRS signal is ON, the values displayed are the same as during a stop.
158
Second monitor
Output current monitor
Second monitor
Output current monitor
rotation speed (output
Third monitor
Output voltage monitor
Third monitor
Cumulative energization time monitor
During
running/stop
Rotation speed Rotation speed
(output frequency) (output frequency)
Output current
Output voltage
Fault display
for 1s after displaying the
Fault monitor
With fault
Fault monitor
With fault
Pr.52
0 100
During stop
Set speed (Set
frequency)
Output current
Output voltage
Fault display
.
During
running
Rotation speed
(output
frequency)