Check and clear of the faults history
(2) Clearing procedure
POINT
Set "1" in Er.CL Fault history clear to clear the faults history.
Operation
1. Screen at power-ON
The monitor display appears.
2.
Press
to choose the parameter setting mode.
3.
Turn
until
appears.
4.
Press
to read the currently set value.
"
" (initial value) appears.
5.
Turn
to change it to the set value "
6.
Press
to set.
Turn
Press
Press
Parameter referred to
Pr.77 Parameter write selection
264
(faults history clear)
".
to read another parameter.
to show the setting again.
twice to show the next parameter.
Refer to page 181
PRM indicator is ON.
(The parameter number read previously appears.)
Flicker... Faults history clear complete!!
Display