Mitsubishi Electric FR-E700EX Instruction Manual page 122

Speed setting by external terminals
(2) Jog operation from outside
 When the JOG (JOG2) signal is ON, a start and stop can be made by the start signal (STF, STR).
 For the terminal used for Jog operation selection, set "5" in any of Pr.178 to Pr.184 (input terminal function selection) to
assign the function.
 To perform JOG operation via a network such as CC-Link, use the JOG2 signal.
To use JOG operation selection 2, set "30" in any of Pr.178 to Pr.184 (input terminal function selection) to assign the function
to a terminal. (Refer to page 138)
Rotation speed
(r/min)
Pr.20
Pr.15 Jog speed setting
setting range
Pr.16
JOG signal
Forward rotation STF
Reverse rotation STR
Operation
1.
Screen at power-ON
 Confirm that the External operation mode is
selected. ([EXT] lit)
If not displayed, press
External (EXT) operation mode. If the
operation mode still does not change, set Pr.79
to change to the External operation mode.
2.
Turn ON the JOG switch.
3.
Turn the start switch (STF or STR) ON.
 The motor runs while the start switch (STF or
STR) is ON.
 The motor runs at 150r/min. (initial value of
Pr.15)
4.
Turn the start switch (STF or STR) OFF.
REMARKS
 When you want to change the running speed, change Pr.15 Jog speed setting. (initial value "150r/min")
 When you want to change the acceleration/deceleration time, change Pr.16 Jog acceleration/deceleration time. (initial value
"0.5s") The acceleration time and deceleration time cannot be set separately for Jog operation.
120
Forward
rotation
Reverse
rotation
ON
ON
ON
to change to the
ON
OFF
Three-phase AC
power supply
Forward rotation
start
Reverse rotation
start
Time
JOG signal
JOG
ON
Forward
rotation Reverse
rotation
Forward
rotation Reverse
rotation
Drive unit
R/L
1
S/L
2
T/L
3
STF
STR
∗
RH(JOG)
SD
10
2
5
∗ When assigning the jog signal to
the terminal RH
Connection diagram
for external Jog operation
Display
Rotates while ON
STOP
U
Motor
V
W