Profienergy Measured Values; Profienergy Energy-Saving Mode - Siemens SINAMICS S120 Function Manual

11.3.10.3

PROFIenergy measured values

Table 11- 17 Overview of the PROFIenergy measured values
PROFIenergy measured
value
ID Name
34 Active power
166 Power factor
200 Active energy
import
11.3.10.4

PROFIenergy energy-saving mode

SINAMICS S120 drive devices support PROFIenergy energy-saving mode 2. The following
two parameters indicate the effective PROFIenergy mode:
● Parameter r5600 indicates the currently active PROFIenergy mode.
● Using interconnectable bits, the r5613 parameter indicates whether the PROFIenergy
energy saving is active.
Activating the energy-saving mode
The energy-saving mode can activated or deactivated using the PROFIenergy control
commands (see also PROFIenergy commands (Page 849)).
General converter behavior when in the PROFIenergy energy-saving mode
● When the PROFIenergy energy-saving mode is active, the converter issues alarm
A08800.
● When the PROFIenergy energy-saving mode is active, the converter does not send any
diagnostic alarms.
● When the PROFIenergy energy-saving mode is active, then the READY-LED flashes
green in the on - off ratio: 500 ms on, 3000 ms off.
● If the bus connection to the control system is interrupted while the converter is in the
energy-saving mode, the converter exits the energy-saving mode and resumes normal
operation ("ready_to_operate").
● The converter changes into normal operation if the control system goes into the stop
condition while the converter is in the energy-saving mode.
Drive functions
Function Manual, 11/2017, 6SL3097-4AB00-0BP5
PROFIenergy accuracy
Domain Class
1 12
1 12
2 11
11.3 Communication via PROFINET IO
Unit SINAMICS source parameters
Parameters
W r0032
1 r0038
Wh r0039[1]
Communication
Value range
Name
Active power Largest value for
smoothed r2004 of all drive
objects
Smoothed pow- 0 ... 1
er factor
Energy accept- -
ed
851