Table of Contents
Advertisement
SAFETY
•
When operating in tunnels, under bridges, under electric wires, or other places where the height is limited,
operate slowly and be extremely careful not to let the machine body or work equipment hit anything.
When traveling on public roads, follow the road traffic regulations and the following:
•
keep the rotating beacon on
•
turn off or obscure the work lights
•
lift the blade and outriggers fully
•
align the references
•
apply the safety catches
•
select the 2WS steering mode
•
activate the street mode
PRECAUTIONS WHEN TRAVELLING ON SLOPES
To prevent the machine from tipping over or slipping to the side, always observe the following.
•
Keep the work equipment approximately 20 to 30 cm
above the ground. In case of emergency, lower the work
equipment to the ground immediately to help stop the ma-
chine.
•
When driving the machine up slopes, set the operator's
cab facing uphill, when driving downhill , set the operator's
cab facing downhill. Always be sure of the safety of the
ground under the front of the machine when driving.
•
When driving the machine up a steep slope, extend the
work equipment to the front to improve the balance, keep
the work equipment approximately 20 to 30 cm above the
ground, and drive it at low speed.
•
When driving the machine downhill, lower the engine speed and drive it at low speed.
•
Always drive the machine straight up or down a slope. Driving the machine at an angle or across the slope
is extremely dangerous.
WENAM00130
PRECAUTIONS FOR OPERATION
2-33
Advertisement
Chapters
Table of Contents
