Komatsu PW118MR-11 Operation & Maintenance Manual page 111

OPERATION
E Mode Recommendation Guidance
If the machine is used with light loads for more than 10 minutes
in P or ATT/P mode, a message that recommends that E mode
is engaged will be displayed. When working on light loads, set
the working mode to E to reduce the fuel consumption.
The E mode recommendation message will turn off after 10
seconds or when switch F5 is pressed.
Guidance for engine stop operation during the aftertreatment devices regenera-
tion
Immediately after starting the aftertreatment devices regeneration, the information about the engine stop opera-
tion during the aftertreatment devices regeneration is displayed.
When stopping the engine during regeneration of the aftertreat-
ment devices, stop the regeneration first according to "PROCE-
DURE FOR SETTING AFTERTREATMENT DEVICES-RE-
GENERATION DISABLE (3-136)", then stop the engine after
running it at low idle for approximately 5 minutes.
The information about engine stop operation during the after-
treatment devices regeneration goes out 10 seconds later or
when switch F5 is pressed.
DEF low level guidance
If the operable time estimated from the current DEF level and
the latest average DEF consumption is shorter than 8 hours,
the low DEF level message is displayed.
The low DEF level message goes out more than 10 seconds
after or when switch F5 is pressed.
METER DISPLAY
ENGINE COOLANT TEMPERATURE GAUGE
Engine coolant temperature gauge shows the engine coolant
temperature.
(A): Red range
(B): Green range
(C): White range
WENAM00130
EXPLANATION OF COMPONENTS
RKA61140
RKA62710
RKA62700
RKA61150
3-39