Table of Contents
Advertisement
EXPLANATION OF COMPONENTS
Automatic lock function of lock lever
•
The lock lever automatic lock function assists the operator in judgment to reduce damage caused
by accident. It does not stop the work equipment or machine in all situations.
•
Even if the lock lever automatic lock function works, the work equipment or machine may not stop
immediately or may stop after moving by a certain distance. Also, the lock lever automatic lock
function may not work in the following cases. Accordingly, do not rely on it too much.
•
When the hydraulic oil temperature is low (When the hydraulic oil temperature caution lamp in-
dicates low temperature)
•
When the viscosity of the hydraulic oil used is higher than that of the genuine hydraulic oils
which Komatsu recommends
•
When system has failure
•
Before setting the lock lever to FREE (F) position, make sure that all levers and pedals are set to
NEUTRAL position. If any of them is out of NEUTRAL position, the work equipment or machine may
move suddenly and cause a serious personal injury or death.
When this function works, the operations of the work equip-
ment, swing, travel, and attachment are locked automatically
and the message shown in the figure is displayed.
While this function is in operation, the machine does not move
even if a control lever or the attachment control switch is oper-
ated while the lock lever is in FREE position (F).
To cancel the lock, return the lock lever to LOCK position (L),
check that each control lever and the attachment switch are in
neutral, and then release the lock lever again.
TRAVEL PEDAL
•
Before operating the drive pedal, make sure that the top turret is facing the oscillating front axle; if
the tower is turned 180°, the controls are inverted.
•
Before moving the machine, make sure that the parking brake has been released, that the swing
axle is free to oscillate and that all the safety locks have been engaged.
•
Non-compliance with these rules may lead to serious accidents.
3-112
k
k
WARNING
k
k
WARNING
WENAM00130
OPERATION
RKA61610
Advertisement
Chapters
Table of Contents
