Table of Contents
Advertisement
ATTACHMENTS AND OPTIONS
2.
Press working mode selector switch (1) or press switches
F3 or F4 to select Breaker Mode B.
Breaker mode B is highlighted in yellow.
3.
With breaker mode B highlighted in yellow, enter the selec-
tion by performing either of the following operations.
•
Hold down working mode selector switch (1).
•
To press switch F6.
•
To leave as it is for 5 seconds.
REMARK
If you press switch F5, the screen returns to "Working
Mode" selection screen without changing to the breaker
mode.
CHECK POINTS WHEN USING BREAKER
•
Is the working mode set to B mode?
•
Is the selector valve set in the breaker position (A)?
•
Do you replace the hydraulic oil and its filter element at intervals shorter than the standard?
The deterioration of the hydraulic oil when using the breaker is much faster than in the normal operations,
so check the maintenance time by referring to "MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER".
When considering whether it is necessary to install an accumulator for the attachment circuit, contact the
attachment manufacturer and then decide.
When handling the breaker, follow the instruction manual from the manufacturer and use the breaker cor-
rectly.
METHOD FOR OPERATING GENERAL ATTACHMENT SUCH AS CRUSHER ETC
Operate attachment 1 proportional switch.
The attachment operates.
CHECK POINTS WHEN USING GENERAL ATTACHMENT SUCH AS CRUSHER
ETC
•
Is the working mode ATT/P or ATT/E?
HANDLE MACHINE READY FOR INSTALLATION OF ATTACHMENT
WENAM00130
RKA65590
RKA48500
6-17
Advertisement
Chapters
Table of Contents
