Komatsu PW118MR-11 Operation & Maintenance Manual page 306

TRANSPORTATION
• Each time the auto-deceleration function key (7) is
pressed, it switches OFF to ON to OFF in turn.
• The auto-deceleration caution lamp (8) switches off
when the function key switches to OFF.
5.
During loading, lift the blade and/or the outriggers and po-
sition the machine with the bucket raised and facing for-
ward.
6.
Before moving onto the ramps, make sure the machine is
aligned with the ramps and that the center line of the ma-
chine is the same as that of the trailer.
7.
Align the direction of travel with the ramps.
8.
Lower the work equipment as much as possible without
causing any interference.
9.
Engage the forward gear (F) and move slowly.
10. When the machine is in position, stop, put it in neutral (N)
and rotate the turret 180 degrees.
11. Lower the blade and/or the outriggers.
12. Extend the bucket and arm cylinders fully, then lower the
boom slowly.
NOTICE
To prevent damage to the bucket cylinder during
transportation, put a block under the tip of the bucket
link to prevent the bucket cylinder from touching the
floor.
13. Set the lock lever to LOCK position (L).
14. Stop the engine, and remove the starting switch key.
15. Close all doors, windows and covers.
NOTICE
Fold the antenna and mirrors so that they are within
the width of the machine.
16. Lock the doors, covers, and caps.
Securing the machine on the means of transport
Having positioned the machine onto the trailer, secure it as follows.
3-234
WENAM00130
OPERATION
RKA61870
RKA48490