Komatsu PW118MR-11 Operation & Maintenance Manual page 294

HANDLE AIR CONDITIONER
AUTO SWITCH
Use the auto switch for automatic selection of the air flow,
vents, and air source (FRESH/RECIRC) according to the set
temperature.
• Press this switch, then use temperature control switch (1)
to set the temperature, and run the air conditioner under
automatic control.
• When switching from automatic operation to manual oper-
ation, it is possible to use the switches to select the vents
and air source (FRESH/RECIRC).
REMARK
When Auto Mode is selected, if the set temperature is set to
18.0 °C or 32.0 °C, the air flow is always set to High, but this is
not a problem.
FRESH/RECIRC AIR SELECTOR SWITCH
Use FRESH/RECIRC air selector switch to switch the air
source between recirculation of the air inside the cab and in-
take of fresh air from the outside.
During automatic operation, the selection of inside air (RE-
CIRC) and outside air (FRESH) is performed automatically.
RECIRC
Outside air is shut off and only air inside the cab is circulated.
Use this setting to perform rapid cooling of the cab or when
outside air is dirty.
FRESH
Outside air is taken into the cab.
Use this setting to take in fresh air or to demist the window glass.
DISPLAY MONITOR
"A/C Setting" (air conditioner setting) screen of monitor (7) indi-
cates the state of temperature setting (a), air flow (b), and
vents (c).
When OFF switch is pressed, the display of temperature set-
ting (a) and air flow (b) goes out, and operation stops.
3-222
WENAM00130
OPERATION
RKA48900