Komatsu PW118MR-11 Operation & Maintenance Manual page 269

OPERATION
• Boom swing control
Depress either the forward or back boom swing control
pedal.
You can swing the boom.
• Blade or outriggers command
Press the blade/outriggers control switch on the right joy-
stick. When the blade/outrigger mode is activated, the icon
(a) is displayed on the machine monitor for 2 seconds and
the selected blade/outrigger can be controlled, the signal
lamp (b) of which turns green.
Move the right joystick back-forward.
Either the blade or the outriggers can be used.
REMARK
Use the switch on the left joystick to rapidly activate the
accessories (blade/outriggers)
If the joysticks are positioned to the NEUTRAL position when the machine is stopped, even if the hand throttle is
set to MAX, the auto-deceleration will reduce the engine speed to the low speed.
REMARK
This machine is equipped with an accumulator in the control circuit. Even if the engine is stopped, if the starting
switch key is turned to the ON position within 15 seconds after stopping the engine, and the lock lever is set to
FREE position, it is possible to use the levers to lower the work equipment to the ground.
This procedure can also be used for releasing the remaining pressure in the hydraulic cylinder circuits or for
lowering the boom after loading the machine onto a trailer.
MACHINE OPERATIONS AND CONTROLS
WENAM00130
B
RKA61820
RKA52370
RKA63070
3-197