Christie Cinema 4K-RGB CP4315-RGB Service Manual page 91

a. Side intake cover (on page 42)
b. Radiator module (on page 63)
c. Radiator fan intake module (on page 59)
d. Light engine fan intake module (on page 60)
e. HKBB cover (A)
2. Detach the color sensor board from the housing and disconnect the harness. Set the board
aside.
3. Remove harnesses from clips on the color sensor housing.
4. Standing at the radiator-side of the projector, disconnect the color sensor board harness from
the HKBB at J85.
5. Remove the color sensor board harness from routing clips starting near the HKBB and finishing
at the P-clip fastened to the base plate in front of the IOS.
6. Gently pull the harness out from underneath the IOS.
Take care when removing the hose as there is a square hole on the underside of the unit which
may have sharp edges.
Cinema 4K-RGB Service Guide–CP4315-RGB, CP4320-RGB, CP4325-RGB, CP4330-RGB
020-102713-03 Rev. 1 (11-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Printed circuit boards and sensors
91