Loading Data To The 'Station; Initializing 'Station - Siemens FS720 Commissioning, Maintenance, Troubleshooting

Connectivity and communication with 'Station'
4

Loading data to the 'Station'

4.5 Loading data to the 'Station'

4.6 Initializing 'Station'

28 | 178
Building Technologies
Fire Safety
Data is loaded from Cerberus-Engineering-Tool to the ↑ 'Station' when the
following commands are performed.
● 'Initialize station'
● 'Download site'
If you use a number of network cards on the PC, observe the information in the
chapter 'IP settings for several network cards' in document A6V10210424. See
chapter 'Applicable documents'.
The table below shows which data is overwritten in the 'Station'.
Command
'Initialize station'
1
'Download site'
Command is only performed for the 'Station' that is connected to the PC via LAN.
1
The configuration of selected 'Stations' or all 'Stations' in the ↑ 'Site' can be
2
overwritten as an option.
See also
2 Loading configuration from the PC to the station [➙ 30]
2 Initializing 'Station' [➙ 28]
● Each ↑ 'Station' in a system with several networked 'Stations' must have a
unique address.
● Once a 'Station' has been started for the first time or once the firmware on the
main CPU has been updated, a 'Station' has the address '1'. Networked
'Stations' must therefore all be initialized.
● If two 'Sites' are merged to form one ↑ 'Site', the 'Stations' with the same
addresses in the added 'Site' must each be given a new address.
● The 'Initialize station' procedure issues the 'Station' an address within the 'Site'
according to the configuration in Cerberus-Engineering-Tool.
A ↑ standalone 'Station' does not have to be initialized.
If you use a number of network cards on the PC, observe the information in the
chapter 'IP settings for several network cards' in document A6V10210424. See
chapter 'Applicable documents'.
Overwrites the Sets the address
↑ BDV of the 'Station'
Yes Yes
Yes No
Overwrites the
configuration
Yes
Yes
2
A6V10210416_j_en_--
2018-08-29