Assigning An As-I Address In Configuration Mode; Assigning A Slave Address; Erasing The Slave Address - Pepperl+Fuchs VBG-CCL-G4F Manual

Shortly appearing configuration errors are stored in the device (advanced AS-i dia-
gnosis). The last error that occurred can be displayed by pressing the set button.
If a short AS-i power failure is responsible for the configuration error the display
shows a "39".
6.4

Assigning an AS-i Address in Configuration Mode

To assign a slave with address unequal zero to another address unequal zero, you
have to follow the instructions first in chapter 6.4.2 and then chapter 6.4.1 one after
the other.
6.4.1

Assigning a Slave Address

(assigning an available address to a slave with address zero)
In configuration mode, the addresses of all detected slaves are displayed one after
the other. To display the next higher available operating address, press the "set"
button shortly. Each time you press the "set" button, the next available address is
displayed.
Choose the displayed address as your target address by pressing the "set" button
for more than five seconds. The address display blinks. The master is ready for
programming; pressing the "set" button again addresses the connected slave with
address zero to the target (blinking address).
Any errors will be displayed by their error codes according to chapter 11. Otherwi-
se, the detected slaves are displayed again as described in chapter 6.2..
6.4.2

Erasing the Slave Address

(assigning address zero to a detected slave)
In configuration mode, the addresses of all recognized slaves are displayed one
after the other. By pressing and releasing the "set" button, the master displays the
next available address. If you press the button for more than five seconds while
the address of a detected slave is displayed, this slave will get the address zero
and the display shows "00".
When you release the button, the display continues to display the detected slaves.
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Operating the AS-i/CC-Link Gateway
Only slaves with address 0 can get a new address by the master.
There must not be two AS-i slaves with the same adrress on the
AS-i circuit.
AS-i/CC-Link Gateway
Copyright Pepperl+Fuchs, Printed in Germany
19