V8 Video Controller - Elan S128P Installation Manual

E L A N H O M E S Y S T E M S

V8 Video Controller

In advanced systems that require additional composite video outputs to some of the S128P's zones, use an ELAN
V8 Video Controller to switch up to eight sources to up to eight zones (or use up to three V8s to switch up to eight
sources to up to twenty-four zones). Connect a composite video cable from each source's Video Loop Output
to an input of the V8. Connect each output of the V8 to a TV, VIA! Touch Panel, or monitor located in a zone, (see
Figure 3-58). Use the ALL IR port on the S128P to control the V8 (see All IR Out Port Connections), or control it seri-
ally from VIA! Touch Panels or Olé Touch Pads using a SS1 System Station connected to the ELAN RS-232 Port (see
RS-232 Connections on page 55).
© ELAN Home Systems 2009 • All rights reserved.
S128P.indd 65
S128P
V8
Figure 3-58: V8 Video Controller
Use PV12 Video
Precision Panels
for S128P Video
Outputs to VIA!
Touch Panels
and TVs
S128P
INSTALLATION MANUAL
Page 65
1/15/2009 1:07:34 PM