Power Connections - Elan S128P Installation Manual

S128P
INSTALLATION MANUAL

Power Connections

It is possible to connect and power up to ten VIA! Touch Panels using the SPP and a 16VDC power supply. Use
punchdown locations "A" and "B" and place the INT V-EXT V switch in the EXT position for each zone that uti-
lizes 16VDC from the connected power supply. Use an ELAN PWR1 16VDC/1.5A power supply for one VIA! Touch
Panels. Use an ELAN PWR4 16VDC/4A power supply for up to four VIA! Touch Panels. Use an ELAN PWR10
16VDC/10A power supply for five-to-ten VIA! Touch Panels. It is also possible to connect up to 66 Olé Touchpads
using the same 16VDC power supplies. A PVIA1 will power up to 6 Olé Touchpads, a PVIA4 can power up to 26 Olé
Touchpads and a PVIA10 Power Supply can support 66 Olé Touchpads. A combination of VIA! Touch panels and Olé
Touchpads can be accomodated. Please consult the chart below for maximum current draw of each device.
NOTE: Only one power supply should be connected to the SPP
Precision Panel at any time!
Page 42
S128P.indd 42
Figure 3-25: SPP Power Connections
E L A N H O M E S Y S T E M S
© ELAN Home Systems 2009 • All rights reserved.
1/15/2009 1:07:13 PM