Elan S128P Installation Manual page 76

S128P
INSTALLATION MANUAL
Figure 5-3 shows Zone 1 with Source 3 selected and a camera selected. The touch panel (1) on Output 1 is display-
ing the camera connected to Input 16, while the monitor connected to Output 2 (5) is displaying Input 3. The * indi-
cates that the output is not tracking with the audio source selected.
Note: This display is only valid for Default Tracking Mode and Source-Select Tracking Mode.
It is invalid for 16 X 16 Mode.
Sense Screen
Press DND again to access the Sense screen. The 12 positions next to "A" correspond to audio sensing. Any
source that is currently playing will be indicated in this location. "P" indicates a Paging signal (either Page Trigger or
Page Audio). "L" indicates that a Local source's audio is present. "S" indicates Sense inputs that are active, while
"V" represents video signals that are present.
Group Screen
Press DND again to cycle to the Group screen. This will show the zones that are in each of the four possible groups
associated with the S128P chassis and whether the Group is currently linked. In the example below, Group 2 is
active and contains Zones 2, 3, and 7. Group 4 is active and contains Zones 5, 6, and 8.
Page 74
S128P.indd 74
V i d e o
1 5 _ _ _ _ _ _
1 1 6*
5 0 3
Figure 5-3: Video Not Tracking with Source
S e n s e
A
L
V
= Active
Figure 5-4: Sense Screen
G r o u p
= Active
Figure 5-5: Group Screen
Z 0 1
_ _ _ _ _ _ _ _
Z 0 1
S
= Inactive
0 1
0 2
0 3
0 4
= Inactive
© ELAN Home Systems 2009 • All rights reserved.
E L A N H O M E S Y S T E M S
S 0 3
S 0 1
P
1/15/2009 1:07:41 PM