Elan S128P Installation Manual page 64

S128P
INSTALLATION MANUAL
Video Output Connections
Video outputs consist of Zone Outputs and Source Loop Outputs. Use high quality video interconnect cables for
all video connections. Video Zone Output Connections: Composite Default Tracking Mode; in the Default Tracking
Mode, there are two pre-configured video outputs for each zone. The first output is configured for a VIA! Touch
Panel, the second output for a TV/monitor. When a video source is selected in a zone, both of these video outputs
will automatically route the selected source video to that zone. The audio will also be automatically routed to the
zone.
The default Composite video zone outputs are:
• Zone 1: Video Outputs 1 - 2 • Zone 5: Video Outputs 9 - 10
• Zone 2: Video Outputs 3 - 4 • Zone 6: Video Outputs 11 - 12
• Zone 3: Video Outputs 5 - 6 • Zone 7: Video Outputs 13 - 14
• Zone 4: Video Outputs 7 - 8 • Zone 8: Video Outputs 15 - 16
S128P
As shown in the diagram below, not every zone will have both a VIA! Touch Panel and a TV/monitor, therefore both
Zone Video Outputs may not always be used.
Composite Video Zone Outputs
Zone 1
VIA!
S128P
Page 62
S128P.indd 62
Composite Video Zone Outputs
Zone 1 Zone 3
VIA! TV VIA!
VIA! TV
Zone 2
Figure 3-52: Default Composite Video Zone Outputs Example #1
Zone 2 Zone 3
VIA!
TV
Figure 3-53: Default Composite Video Zone Outputs Example #2
E L A N H O M E S Y S T E M S
(Default example / Zones 1-3 shown)
TV
(additional example / Zones 1-4 shown)
Zone 4
TV
© ELAN Home Systems 2009 • All rights reserved.
1/15/2009 1:07:31 PM