Elan S128P Installation Manual page 65

E L A N H O M E S Y S T E M S
Video Zone Output Connections: Component
Component video outputs are grouped using VIA!TOOLS or ELANTOOLS setup software. As
with the Component video inputs, these outputs are designated by a letter and
go backwards in order. Output 16 is not used as a Component video output.
These groups are labeled:
• A: Outputs 13, 14, 15 • D: Outputs 4, 5, 6
• B: Outputs 10, 11, 12 • E: Outputs 1, 2, 3
• C: Outputs 7, 8, 9
Use high quality Component video cables to connect from the S128P's Zone Video
Outputs to TVs or monitors located in specific zones of the house. Please consult
VIA!TOOLS or ELANTOOLS software for additional information about Component video routing.
Component Video Zone Outputs
S128P
Video Zone Output Connections: Composite & Component
The S128P allows you to route both Composite video and Component video simultaneously. Connect the Video
Zone Outputs as needed, making sure to maintain Group connections for Component video. Use VIA!TOOLS or
ELANTOOLS setup software to assign outputs to specific zones as required by the system's architecture. See
VIA!TOOLS or ELANTOOLS for detailed programming instructions.
© ELAN Home Systems 2009 • All rights reserved.
S128P.indd 63
Figure 3-54: Component Video Zone Outputs
Composite/Component Video Zone Outputs
Zone 1 Zone 2 Zone 3
VIA! VIA!
VIA!
S128P
Figure 3-55: Composite and Component Video Connections
(Outputs A & B Shown)
TV
TV
Zone 5
S128P
INSTALLATION MANUAL
TV
TV
Zone 7
Page 63
1/15/2009 1:07:32 PM