Emergency Call; D Transmitting An Emergency Call - Icom IC-F7010 Series Operating Manual

4
ADVANCED OPERATION

Emergency call

IMPORTANT: It is recommended that the dealer sets
an Emergency channel in each zone, to provide a
reliable Emergency call operation.
NOTE: Depending on the presetting, the following
functions may be automatically activated.
Auto TX function
After an Emergency call transmission, the
transceiver transmits the microphone audio for a
preset period of time.
Auto RX function
After an Emergency call transmission, the
transceiver stands by in the Audible mode for a
preset period of time.
TIP: A user can transmit the Emergency call in the
2-Tone, APCO P25, or MDC 1200 signaling system.

D Transmitting an Emergency call

When the transceiver enters the Emergency mode, a
countdown starts. The transceiver counts down during
the Reminder Timer set time.
Before the Reminder Timer set time expires, the
transceiver transmits an Emergency call once, or
repeatedly*, on the specified Emergency channel.
If no Emergency channel is specified, the Emergency
call is made on the previously selected channel.
* Depending on the presetting.
L The transceiver automatically transmits a repeat
Emergency call until the [Back] key is pushed, it
receives an acknowledgement, or until a user turns
OFF the transceiver.
L If the transceiver is set for Silent operation, it
transmits an Emergency call without a beep
sounding or the status indicator lighting.
The transceiver enters the Emergency mode through
the following functions:
• The [Emergency] key
When a user holds down [Emergency] for the Emer
SW ON Timer preset time.
L If a user holds down [Emergency] for the Emer SW
OFF Timer set time before the Reminder Timer set
time expires, the Emergency mode is canceled.
(Example)
• Emer SW ON Timer: 10 seconds
• Reminder Timer:
Enters the
Emergency mode.
10 sec.
ON Timer
[Emer]
4-3
10 seconds
Sends an
Emergency call.
10 sec.
Reminder Emergency
Timer Timer
Time
☞ Continued on the next page.