Emergency Call - Icom IC-V10MR Operating Manual

■ Emergency call

When pushing [Emergency] for the set time period*, the
transceiver transmits an emergency signal once, or repeat-
edly, on the specified emergency channel.
The transceiver automatically transmits a repeat emergen-
cy signal until it receives an acknowledgement signal, or you
turn OFF the transceiver power.
When no emergency channel is specified, it transmits the
signal on the previously selected channel.
If you want to cancel the emergency call, hold down [Emer-
gency] again before transmitting the call.
If your transceiver is programmed for Silent operation, you
can transmit an Emergency call without the beep sounding
and the LED indicator lighting.
IMPORTANT: It is recommended to set an emergency
channel individually to provide the certain emergency call
operation.
NOTE:
Depending on the presetting, the following functions are
automatically activated. Ask your dealer for details.
• Auto TX function
After an emergency call transmission, the transceiver trans-
mits the audio from the microphone for a set time period.*
• Auto RX function
After the emergency call transmission, the transceiver stands
by in the audible mode for the set time period.*
* Depending on the presetting. Ask your dealer for details.
2
BASIC OPERATION
2 2
8