Function Display (For The Portable Type Transceiver); D Icon Area - Icom IC-F7010 Series Operating Manual

2
PANEL DESCRIPTION

Function display (for the Portable type transceiver)

q
NOTE: The screen capture is an example. The
displayed position of each icon may differ, depending
on the function being used.

D Icon Area

Indicators
q SIGNAL STRENGTH INDICATOR
Displays the relative receive signal strength level.
w CLOCK
Displays the current time.
L "AM" or "PM" is displayed beside the time display when
the 12 hour display format is selected.
L "--:--" is displayed instead of the current time when the
internal clock is not set.
e BATTERY INDICATOR
Displayed or blinks to indicate the battery status.
Indication
Battery
Full
status
blinks when the battery is exhausted.
Icons
The following icons are displayed in the Icon Area.
POWER ICON
• "L1" is displayed when the output power is set to Low.
• "L2" is displayed when the output power is set to Mid.
• "H" is displayed when the output power is set to High.
AUDIBLE ICON
Displayed when the channel is in the 'audible'
(unmute) mode.
MESSAGE ICON
• Blinks after Messages (Message or Status Message)
have been received.
• Stops blinking when the screen is changed, or any
key is pushed, but is displayed if unread messages
are still in the Message memory.
• Disappears when all messages in the Message
memory have been read.
w
e
Icon Area
Charging Battery
Mid
required exhausted
BELL ICON
Displayed when a matching signal is received,
depending on the presetting.
SCAN ICON
• Displayed when a scan is paused.
• Blinks while scanning.
SCAN TARGET CHANNEL ICON
Displayed when the channel is selected as a scan
target channel.
SCRAMBLER/ENCRYPTION ICON
In the Analog mode
Displayed when the Voice Scrambler function is ON.
In the Digital mode
• Displayed when the Voice Encryption function is ON.
• Blinks when decoding an encrypted signal.
GPS ICON
• Displayed when valid position data is received.
• Blinks when searching for satellites or calculating
position data.
L Depending on the presetting, the GPS icon is not displayed.
RECORD ICON
• Displayed when the Record function is ON.
• Blinks while recording audio.
L " " is displayed when there is no microSD card free
space and audio cannot be recorded.
TALK AROUND ICON
Displayed when the Talk Around function is ON.
PHONE ICON
• Displayed when the transceiver is connected to a
telephone network on the selected channel.
• Blinks while receiving a phone call.
SITE LOCK ICON
Displayed when the Site Lock function is ON.
LONE WORKER ICON
Displayed when the Lone Worker function is ON.
MOTION SENSOR ICON
Displayed when the Motion Sensor function is ON.
NOISE CANCEL ICON
Displayed when the Noise Cancel function is ON.
SURVEILLANCE ICON
Displayed when the Surveillance function is ON.
2-3
☞ Continued on the next page