Copying Data From A Transceiver; D Connecting; Options - Icom IC-F7010 Series Operating Manual

13
OTHERS

Copying data from a transceiver

This section describes how to copy data from a
Master transceiver to a Sub transceiver using the
optional OPC-1870 or OPC-2362
The copying procedure differs, depending on the type
of the Master transceiver used.
NOTE: Before copying, set the "Transceiver Data
Out" item to "ON" using the CS-F7500
.
software

D Connecting

Before copying, connect the Master and Sub
transceivers using the optional OPC-1870 or OPC-
2362 .
zone copy cable
1. Turn OFF the Master and Sub transceivers.
2. Connect the two transceivers with the cable.
The following cables are used:
• OPC-1870: Used between a Portable and a
Portable.
• OPC-2362: Used between a Portable and a
Mobile.
Portable and Portable connection
Turn OFF
Portable and Mobile connection
Turn OFF
zone copy cable
programming
OPC-1870
Turn OFF
Turn OFF
OPC-2362
D Copying data
.
Step 1: Enter the Programming mode
1. While holding down [P1] and [Down], turn ON
the transceiver. Continue holding down [P1] and
[Down] for about 3 seconds.
• 2 beeps sound.
2. Push [Up] or [Down] to select "Programming."
• The transceiver enters the Programming mode.
Step 2: Turn ON the transceiver
Step 3: Copy data
Push [PTT] (Portable) or Power switch (Mobile) to
start copying data to the Sub transceiver.
Step 4: Complete
After copying is completed, the Master and Sub
transceivers automatically restart.
• The user can operate the Sub transceiver with the loaded
data.
13-4
(Master)
(Sub)
(Master)
(Master/Sub)