Preparations For Commissioning; Checking The Axis String; Switching On The Power Supply, Switch−On Behaviour - Festo CPX-CMAX-C1-1 Mounting, Installation And Diagnostics

4. Commissioning
4.2

Preparations for commissioning

4.2.1 Checking the axis string

4.2.2 Switching on the power supply, switch−on behaviour
4−8
Prior to commissioning:
Check the complete system structure, especially the drive
·
tubing connections and the electrical installation (see
chapters 2 and 3).
It is possible to pre−parameterize the CMAX even without the
components on the axis interface.
Warning
High acceleration forces on the connected actuators! Unex
pected motions can cause collisions and severe injuries.
Switching on:
·
Always first switch on the valve load voltage supply and
then the compressed air supply.
Switching off:
·
Before mounting, installation and maintenance work, put
the system into a safe state (e.g. by putting the drive in a
safe position and deactivating the controller).
Always make sure that the compressed air and valve load
voltage supplies are switched off and locked before
working in the machine area.
Festo P.BE−CPX−CMA X−SYS−EN en 0908NH