Intended Use - Festo CPX-CMAX-C1-1 Mounting, Installation And Diagnostics

Contents and general safety instructions

Intended use

Festo P.BE−CPX−CMA X−SYS−EN en 0908NH
The CPX−CMAX−C1−1 axis controller documented in this
description is intended exclusively for use in Festo CPX
terminals for installation in a machine or an automation
system.
In connection with a CPX terminal with suitable CPX bus
nodes or CPX−FEC, as well as with enabled drives with a
displacement encoder as well as a VPWP proportional direc
tional control valve, CMAX serves as a position controller with
position and force control for pneumatic drives.
The CPX terminal may only be used with the CMAX as follows:
As intended for the industrial environment
In its original condition without unauthorised modifica
tions. Only the conversions or modifications described
in the documentation supplied with the product are per
mitted.
In perfect technical condition.
Only in combination with approved components
(valves, drive/displacement encoder combinations,
see section 1.2).
The limit values specified for pressures, temperatures, electri
cal data, torques etc. should be observed.
Please comply with regulations of the trade associations,
the German Technical Control Board (TÜV), the VDE or the
relevant national regulations.
VII