Mounting/Dismounting The Cmax - Festo CPX-CMAX-C1-1 Mounting, Installation And Diagnostics

2. Fitting and pneumatic installation
2.2

Mounting/dismounting the CMAX

Removal
1
CMAX
2
Interlinking block
3
Contact rails
4
Torx T10 screws
Fig. 2/2: Mounting/dismounting the CMAX
2−4
The CMAX is mounted in an interlinking block (see also
section 3.4) of the CPX terminal. See Fig. 2/2.
Note
Always switch off the power supply before mounting/
·
dismounting CPX modules.
Note
The CMAX contains electrostatically sensitive devices.
Therefore, do not touch any of the components.
·
Observe the handling specifications for electrostatically
·
sensitive devices.
Remove the CMAX as follows:
1. Loosen the four screws of the CMAX with a T10 Torx
screwdriver.
2. Pull the CMAX carefully and without tilting away from the
contact rails of the interlinking block.
4
3
Festo P.BE−CPX−CMA X−SYS−EN en 0908NH
1
2