Special Functions; Control Lock; Programmable Show Me Button; Reset To Factory Default Settings - Lightware HDMI-TPS-TX210 User Manual

Example (video input ports on an SW4-TPS-TX240)
The priority values have to be assigned to each input port which are desired to use. The
following priority settings will be used during the explanation of this mode:
After an event the device always checks the port with the highest priority, P2 (HDMI2). If
there is a valid signal on P2, it will be selected. If there is no valid signal on HDMI2 input
port the device checks the following port with priority 1, P3 (HDMI3). If there is a valid signal
on P3, it will be selected. If there is no valid signal on HDMI3 input port the device checks
the following port with priority 2, P4 (DVI-D). If there is a valid signal on P4, it will be
selected. If there is no valid signal on DVI-D input port the device checks the following port
with priority 3, P1 (DP). If there is a valid signal on it, P1 will be selected. If there is no valid
video on any of the checked input ports, the No sync-screen state will be checked; if the
function is in On/Auto state, No sync-screen will be displayed. If the state is Off, there will
be no Audio/Video transmission.
Port priority settings
Autoselect priority settings can be changed via the LDC surface, see section
or by protocol commands.
Special features
The same priority number can be set to different ports. In this case the input port with the
lowest port number will have the highest priority among them. E.g. setting the priority of P2
(HDMI2) and P3 (DP) to "0", the HDMI2 input port will have higher priority since P2 is lower
than P3. Ports can be skipped from the priority list by giving the lowest value: priority 31.

5.2. Special functions

5.2.1. Control lock

Press the Audio select and Show Me buttons together (within 100 ms) to disable/enable
front panel buttons; front panel LEDs blink 4 times when locking/unlocking. If the control
lock is enabled and a button is pressed, front panel LEDs blink 3 times quickly.

5.2.2. Programmable Show me button

Action or an operation can be assigned to the Show me button. "Show me button pressed"
is a condition that can be selected in the Event manager. See more details in section
on page 51.

5.2.3. Reset to factory default settings

To restore factory default values, do the following steps:
Step 1. Make sure the device is powered on and operational (control is not locked).
Step 2. Press and keep pressed the Show me button for 10 seconds.
Step 3. After 5 seconds front panel LEDs start blinking but keep on pressing the button.
Step 4. After 10 seconds the blinking gets faster; release the button and press it 3 times
Step 5. The LEDs get dark, the device restores the factory default settings and reboots.
Factory default settings are listed in section
Page 32 / 122
Priority
Input port
HDMI2
again quickly (within 3 seconds).
0 1
P2 P3
HDMI3
11.5 on page 120.
2 3
P4 P1
DVI-D DP
0
Section 5. Front panel operations
on page 43,
6.9