Setting Up The Service Processor Using The Hpe 3Par Guided Setup - HPE 3PAR StoreServ 9000 Customer Self Install Manual

• The access privileges to the storage system are obtained.
• The service processor setup is complete for the service processor.
• The service processor and storage system are connected to the network and the service processor is
on the same network subnet as the storage system.
Setting up the service processor using the HPE 3PAR
Guided Setup
Procedure
1. To access the HPE 3PAR Guided Setup, connect to the service processor (SP) through a browser with
the SP IP address: https://<sp_ip_address>:8443/.
IMPORTANT: If you receive a warning from your browser when you enter the SP URL, see
Browser warning when connecting to the service processor on page 89. Later, you will be
able to install appropriate certificates so that you do not see this warning message in the future.
The Guided Setup window opens and displays three steps. Notice that you have already completed
Step 1, Connect Service Processor. You can now proceed with Step 2, Setup the Service
Processor.
2. To close the Guided Setup window, click Continue.
3. Click Setup Service Processor.
4. Follow the instructions in the Setup Service Processor window. Setup either a new uninitialized SP
or restore the existing SP using a recovery file.
Under network settings, you have a chance to review and correct any information that you entered in
Step 1. If you check IPv6, you will be prompted to enter the IPv6 address, subnet prefix length, and
gateway. More network speed, domain, and DNS adjustments to the SP network configuration can
also be set.
Scroll down to complete each section in the window. You can enter the following information:
• Date and Time settings
• The admin and hpepartner login credentials from the Software Setup Worksheet
• Support settings, including enabling email notifications
5. To apply the settings, click Setup.
The Guided Setup window displays describing the status and next steps.
You will be able to follow the setup progress on the Service Processor Setup screen. The full list of
initialization steps are displayed on the right side the screen with the status, while the steps that have
not yet been completed are listed on the left side of the screen.
If the setup remains incomplete due to an error, the checklist displays the error with a link to the
section of the setup dialog related to the error condition.
If a WARNING is displayed instead of an error, continuing with the setup is an option.
6. Click Continue to be taken to the Service Processor Setup page to monitor the initialization of the
SP.
Setting up the service processor and storage system software: Process overview 47