HPE 3PAR StoreServ 9000 Customer Self Install Manual page 19

WARNING: Before rolling the rack from the pallet to the floor, correctly install the ramp
supports underneath the ramps, which will prevent the ramps from collapsing or causing the
rack to tip as it is moved down the ramps.
d. Attach the wooden ramp supports designated A and B to the locations on the ramps designated A
and B. Ensure that the angle of the wooden ramp support is attached to the ramps at the same
angle. The letters are marked on the ramp inside edge and support edge. Install support A beneath
the general area marked A on the rack, and do the same for support B. Insert the ramp support
beneath the ramp where the bottom of the ramp support touches the ground and the velcro on the
top of the ramp support is secure to the velcro underneath the ramp. The wooden ramp supports
must fit snugly between the ramp and the floor.
Figure 11: Installing the ramp supports, HPE rack shipping container
9. Roll the rack from the pallet to the floor.
CAUTION: When unloading the rack from the pallet, always use at least three people and do not
stand in front of the rack.
To roll the rack off the pallet to the floor, each person must grasp the rack corners with two people
guiding the rack down the ramp while a third person slowly pushes the rack from behind. Based on the
weight of the rack, it may be necessary to have both people on the side carefully push the rack until it
is completely on the ramp and adjust to guiding the rack the rest of the way down the ramps and onto
the floor.
Unpacking the factory-integrated-in-rack option: Process overview 19