Setting Up The Physical Service Processor Connection: Process Overview; Using The Guided Setup-Sp5.X - HPE 3PAR StoreServ 9000 Customer Self Install Manual

• For communication between the service processor and the HPE 3PAR StoreServ Storage system, the
customer network must allow access to the following ports on the storage system.
◦ Port 22 (SSH)
◦ Port 5781 (Event Monitor)
◦ Port 5783 (CLI)
• For communication between the browser and the service processor, the customer network must
enable access to port 8443 on the SP.
• For communication between the vCenter instance and the service processor, the customer network
must enable access to port 443 (default port) on the SP and vCenter server.
Setting up the physical service processor connection:
Process overview
Procedure
Complete Assigning an IP address to the physical service processor with a functional network
using the Guided Setup—SP5.x on page 40.
Assigning an IP address to the physical service processor with a functional
network using the Guided Setup—SP5.x
Prerequisites
• The physical service processor (SP) and the HPE 3PAR StoreServ Storage are connected to a
network with a gateway.
• The service processor must be on the same subnet as the HPE 3PAR StoreServ Storage system.
Procedure
1. Connect a service laptop to the physical service processor.
With an Ethernet cable, connect a private Ethernet switch/hub between an Ethernet port on a service
laptop and the service port on the physical service processor.
IMPORTANT: Hewlett Packard Enterprise recommends using a private Ethernet switch/hub for
connection between a service laptop and a physical service processor to ensure that the service
laptop does not lose its network connection during the procedure. The loss of a network
connection can result in a failure of the procedure. Any Ethernet switch/hub with four to eight
ports is supported, such as the HPE 1405-5G Switch (J97982A).
40 Setting up the service processor connection: Process overview