Assigning An Ip Address To The Virtual Service Processor With Hyper-V - HPE 3PAR StoreServ 9000 Customer Self Install Manual

Procedure
1. Execute the Hyper-V deployment executable as administrator.
2. Click Install.
3. Enter the name of the virtual machine to be created.
4. Select the interface from the available virtual network switches by entering the index associated with
the switch. (Available only if there is more than one virtual switch configured.)
5. After the virtual machine is configured, press Enter to continue.
6. In the Hyper-V Manager, select the virtual machine, and then click Start in the Actions pane.
7. Once the virtual machine has booted up, log in as admin (no password) and note the virtual machine
IP address.
8. Connect to the service processor through a browser with the service processor IP address using the
format https://<sp_ip_address>:8443, where <sp_ip_address> is the IP address you noted
in the previous step.

Assigning an IP address to the virtual service processor with Hyper-V

Procedure
1. In the Hyper-V Manager, right-click the virtual machine from the Virtual Machines list and then click
Connect....
2. Click the green on/off button labeled Start in the virtual service processor console menu.
It might take a minute or two for the login prompt to appear.
3. Log in with the admin credentials and then press Enter.
A password is not required to configure the network settings.
4. Enter the service processor IP address and then press Enter.
5. Enter the netmask address and then press Enter.
6. Enter the default gateway address and then press Enter.
7. Review the configuration confirmation and record the service processor IP address on to the HPE
3PAR StoreServ 9000 Storage Software Setup Worksheet for reference during subsequent setup
procedures with the software HPE 3PAR Guided Setup.
8. To exit, press Enter.
Setting up the service processor connection: Process overview 45