HPE 3PAR StoreServ 9000 Customer Self Install Manual page 16

4. Remove the packing material (wrapping material, foam pieces, plastic ESD cover), and then set aside
the boxes that hold the ramps and additional installation hardware.
Figure 6: Removing the packing material, HPE rack shipping container
5. Remove the four shipping L-brackets that attach the rack to the pallet using a socket wrench with 13
mm (1/2 in) and 17 mm (11/16 in) sockets.
a. Starting at the rack front, open the door and locate the two L-brackets.
b. Remove the two 13 mm (1/2 in) bolts that secure the L-bracket to the rack.
c. Remove the two 17 mm (11/16 in) bolts that secure the L-brackets to the pallet.
d. At the rack rear, repeat this same procedure to remove the remaining two L-brackets.
6. Check that the leveling bolts are raised to provide sufficient clearance for removing the rack from the
pallet.
a. If it is necessary to raise a leveling bolt, use an adjustable wrench and turn the upper locking nut
clockwise to loosen.
16 Unpacking the factory-integrated-in-rack option: Process overview