HPE 3PAR StoreServ 9000 Customer Self Install Manual page 41

Figure 22: Physical service processor ports, HPE ProLiant DL120 Gen9 Server
Figure 23: Physical service processor ports, HPE ProLiant DL360 Gen10 Server
1 Management (MGMT) port; NIC 1
2 Service port; NIC 2
2. Temporarily configure the LAN connection of the service laptop as follows:
IP Address: 10.255.155.49
Subnet mask: 255.255.255.248
3. To begin the HPE 3PAR Guided Setup, access the service processor from the service laptop:
a. In a browser window, enter: https://10.255.155.54:8443/
b. Read the HPE End-User License Agreement and then click Accept.
c. Click Continue and then click Connect Service Processor.
d. Enter the information for the service processor network connection from the Software Setup
Worksheet and click OK.
e. Wait for the Step 1 Completed message, but do not click Continue. Instead, disconnect the
laptop Ethernet cable that you directly connected to the service port on the physical service
processor in step 1.
f. Reconnect your service laptop to the same network as the service processor and HPE 3PAR
StoreServ Storage system.
Setting up the service processor connection: Process overview 41