Hpe 3Par Storeserv 9000 Storage Software Set Up Worksheet - HPE 3PAR StoreServ 9000 Customer Self Install Manual

HPE 3PAR StoreServ 9000 Storage Software
Set up Worksheet
To prepare for the software setup using the HPE 3PAR Guided Setup software, complete this worksheet.
Information is needed for the HPE 3PAR Service Processor, the HPE 3PAR StoreServ 9000 Storage system,
and the HPE 3PAR StoreServ Management Console (SSMC).
IMPORTANT: The HPE 3PAR Guided Setup software is available for the initial installation. If the
installation must be performed again (for example, due to a relocation of the storage system), contact your
Hewlett Packard Enterprise support representative. Record user names and passwords only in a secure
location.
Name
IPv4 (required): address, subnet mask, gateway,
network speed
IPv6 (optional): address, subnet prefix length, gateway
DNS server (optional)
Record DNS server addresses.
NTP server (optional)
Record network time server addresses.
Administrator account password
(Preset user name is admin.)
HPE Partner account password
(Preset user name is hpepartner.)
Remote Support proxy (optional)
Record proxy name, IP address, and port.
Send email notifications of alerts (optional)
Record mail host name, IP address, domain, and email
addresses.
1
The password can be 8-32 characters in length and must contain at least one uppercase letter and one lowercase
letter, one digit, and one nonalphanumeric character.
HPE 3PAR Service Processor
1
1

HPE 3PAR StoreServ 9000 Storage Software Set up Worksheet

95