Adding Workstations To The Public Firewall Rules - HPE 3PAR StoreServ 9000 Customer Self Install Manual

TIP: The default port number is 8443. Another port might have been assigned during
installation of the software.
The login screen opens.
b. Enter a user name and password, make sure the check box for Administrator Console is clear,
and then click Login.
The Dashboard screen is displayed.
7. From the Main Console interface dashboard, complete the following steps:
a. From the main menu under Storage Systems, click Systems.
b. Select the storage system from the list pane view.
c. From the detail pane view for that system, hover over the General detail area, and then click the
edit icon (
d. Scroll down to the Descriptors section, and then paste the token in the Comments field.
With this token added, the next time the storage system calls home, StoreFront Remote will see the
storage system and associate it with the corresponding group. This process can take 24–48 hours.

Adding workstations to the public firewall rules

If Permissive Mode is enabled, adding workstations to the public firewall rules is not necessary.
After verifying the service processor (SP) connectivity, add the management workstation (host) IP
address to the service processor public firewall rules to allow access to the service processor. For
example, you can use a management workstation to connect to the service processor to stop or start
external communications.
Procedure
1. Connect and log in to the service processor.
a. Browse to the IP address https://<sp_ip_address>:8443/.
b. Enter the account credentials and then click Login.
2. Open the Service Console (SC) main menu by clicking 3PAR StoreServ Service Console in the
upper-left corner.
3. From the main menu, select Service Processor.
4. On the Service Processor page, select Actions > Edit SP configuration.
5. From the Service Processor Firewall section of the Service Processor Settings dialog, click the
Add button under Rules.
6. To add the workstations, enter the IP address or range of at least one management workstation, and
click the Add button. (Or, click the Add + button to continue adding addresses.)
7. Verify the addresses in the Service Processor Settings dialog.
8. If not already disabled, disable Permissive mode.
52 Post-installation tasks
) that appears near the panel name.