Problem Of Installing Os - NEC Express5800 Series Maintenance Manual

Chapter 1 Maintenance
5.3

Problem of Installing OS

[?] I cannot create a partition when installing Windows Server 2012 R2 or Windows Server 2012.
Was the following message displayed?

→If the above message is displayed, it means that you failed to create a partition.
In this case, delete the partition you attempted to create, and then create a new partition.
If you have connected a data disk to a partition, be careful not to delete that partition.
Was the following message displayed?

→ This message is displayed if the user continues to install the OS without the relevant partition
being created correctly.
If the above message is displayed, stop installation, delete the partition you attempted to create
for installing the OS, create a new partition, and then start installation again. If you have
connected a data disk to a partition, be careful not to delete that partition.
[?] Unable to install OS
Is the solid state drive properly installed?

→ Make sure that the solid state drive is installed securely and that cables are properly connected.
Is the format of the disk on which you are going to install the OS supported in your BIOS environment?

→ The supported disk formats differ as follows depending on the BIOS environment.
BIOS
environment
UEFI
Legacy BIOS
Disk format
GPT (GUID partition table)
MBR (master boot record)
Express5800/B120f Maintenance Guide
5. Troubleshooting
29