NEC Express5800 Series Maintenance Manual page 203

Chapter 3 Appendix
●
Messages displayed on an upper LCD line
BIOS Message on
Upper LCD Line
XX BIOS Rev
XXXX
POST Completed
Successfully
No Available
Memory in System
Error Pause in
POST
Entering BIOS
SETUP MENU
Waiting for normal
temperature
BIOS Updater
Running
System
Configuration
change is detected
PCI Bus System
Error x (x: number)
PCI Bus Parity
Error x (x: number)
CPUx_DIMM X
Correctable Error
(x: number)
Memory DIMM
Sparing Fail - over
on CPUx (x: CPU
socket number)
Memory DIMM
Mirroring Fail - over
on CPUx (x: CPU
socket number)
Cause
POST in progress.
POST completes normally.
No available memory is installed.
An error occurred during POST.
Starting up BIOS SETUP MENU.
A temperature abnormality was detected
inside the server.
BIOS update is in progress.
The CPU or memory configuration has
changed since the previous startup.
A system error occurred in the PCI bus.
A parity error occurred in the PCI bus.
A correctable error occurred frequently in
CPU #1_DIMM.
X: Failed DIMM number (1-origin)
The Memory Sparing feature switched the
DIMM to a DIMM in the standby state.
The Memory Mirroring feature switched the
DIMM to a DIMM in the standby state.
Express5800/B120f Maintenance Guide
1. Error Message of POST and Virtual LCD
Solution
Wait until POST completes.
Wait until booting up completes.
Make sure that the memory is correctly installed.
Check the error message which appears
on-screen, and take the appropriate action for
each error.
This message will disappear when SETUP
operation is completed.
Lower the room temperature or turn off the
power to cool the server to room temperature
before starting up the server. If this abnormality
continues to occur, check if a fan has failed. If
the same message still continues to appear,
contact your sales representative.
Wait until BIOS update is completed.
If this message appears even when no
configuration change has been made, contact
your sales representative
Contact your sales representative.
203