Table of Contents
Advertisement
3.6.5
Installing Digital Video Printer
1. Put the printer in a proper place.
2. Plug the printer power cord to an appropriate outlet.
3. Use a USB cable to connect between the USB port of the system and the USB port
of the printer.
4. Load a paper roll, and turn on the system and printer.
5. See section "3.6.3 Graph /Text printer" for driver installation procedure (drivers of
printers listed in the "2.5.4 Peripherals Supported" chapter are installed already).
Add a print service:
(1) Open the [Setup] [Print Preset] [Print Service] screen.
(2) Click [Add Service] to enter the Print Service page.
(3) Select the service type and enter the service name manually.
(4) Click OK to return to the Printer Service page.
(5) Set printing properties.
(6) Click [OK] to complete the setting.
Modify print service:
(1) Select an existed printer service in the list.
(2) Select the printer model, and then you can set the properties in the Property box.
(3) Click [OK] to complete the setting.
3.6.6
Installing a Wireless Printer
The system supports wireless graph/text printer for report printing.
1. Plug the printer power cord into an appropriate outlet.
2. Power the system and the printer on.
3. Make sure the ultrasound machine and the printer are connected to the same LAN,
and turn the printer's W-LAN function on.
4. Add a wireless adapter, following the steps described in "Add network printer." See
chapter "3.6.3 Graph /Text printer" for details.
5. Open the [Setup] [Print] page, select "Report Print" from the printer list, select the
printer to be the wireless printer, and set properties.
6. Click [Save] to exit the preset and make the settings effective.
3.6.7
Installing/ uninstalling Probe/Gel Holder
Installing
As shown in the figure below, align the buckle of the holder to the slot at the side of the
control panel and then insert the buckle into the slot until the buckle clicks and locks.
3-16 System Preparation
Advertisement
Table of Contents
